Filter
Top Products
Programming
37
*1 If you set the line selection mode from “Auto” to “Line1” or “Line2” (page 19), the
auto talk feature will function for that line only. If the other line receives a call, the auto
talk feature does not function.
*2 If you subscribe to Caller ID service and want to view the caller’s information after lifting
up the handset to answer a call, turn off this feature.
*3 If you programme these settings using one of the handsets, you do not need to
programme the same item using another handset.
*4 This tone lets you know when you receive a call while you are on the other line, on an
intercom call, or monitoring a room. If you select “On”, the tone sounds repeatedly for
as long as the line rings. If you select “2”, the tone only sounds 2 times.
*5 Turn this feature off if you prefer not to hear key tones while you are dialling or pressing
any keys, including confirmation tones and error tones.
*6 If you select one of the melody ringer patterns, the ringer continues to sound for several
seconds if:
– the caller hangs up before you answer the call.
– another person answers the call using another phone connected on the same line.
*7 The recall time depends on your telephone exchange or host PBX. Consult your PBX
supplier if necessary.
You can access your service provider/telephone company “Call Waiting” service by
having the recall time set at 100 ms, and then follow your service provider/telephone
company “Call Waiting” instructions to operate this service.
*8 Generally, the line mode setting should not be adjusted. If k or l is not displayed
on the handset or the LINE1 or LINE2 indicator on the base unit does not light properly
when another phone connected to the same line is in use, you need to change the line
mode to “A”.
Set line mode
*3*8
Line1 {0}{5}{3}{1}{1}: A {2}: <B>–
Line2 {0}{5}{3}{2}
Voice enhancer {5}{1}: On {0}: <Off>24
Feature Feature code Setting code Page
TG6700AL.book Page 37 Tuesday, June 27, 2006 2:08 PM