Filter
Top Products
Preparation
19
Setting the unit before
use
Important:
LTo programme features by scrolling
through the display menus, see page 33.
Date and time
Set the correct date and time. When you
play back a message from the answering
system (page 40), the unit announces the
day and time it was recorded.
1 {MENU} i {4}
2 Enter the current day, month, and year
by selecting 2 digits for each.
Example: 15, August 2006
{1}{5} {0}{8} {0}{6}
3 Enter the current hour and minute (12-
hour clock format) by selecting 2 digits
for each.
Example: 9:30
{0}{9} {3}{0}
4 Press {AM/PM} to select “AM” or “PM”.
i {SAVE} i {OFF}
Note:
LIf you make a mistake when entering the
date and time, press {<}, {>}, {^}, or
{V} to move the cursor, then make the
correction.
LIf a power failure occurs, E flashes on
the base unit to indicate the date and
time must be set again.
Line selection
The line selection mode determines which
line is selected when you press {C} on
the handset or {SP-PHONE} on the base
unit. The default setting is “Auto”.
–“Auto”: When making a call, line 1 is
selected. If that line is unavailable, line 2
is selected. When answering a call, the
ringing line is selected.
–“Line1”: Line 1 is selected.
–“Line2”: Line 2 is selected.
Handset line selection
1 {MENU} i {0}{5}{5}
2 Select the desired setting. i {SAVE}
i {OFF}
Note:
LYou can select a line manually
regardless of the line selection mode by
pressing {LINE1} or {LINE2}.
Base unit line selection
1 {MENU} i {0}{*}{5}
2 Select the desired setting. i {SAVE}
i {OFF}
Note:
LYou can select a line manually
regardless of the line selection mode by
pressing {LINE1} or {LINE2}.
Handset
Handset
Handset
TG6700AL.book Page 19 Tuesday, June 27, 2006 2:08 PM