Filter
Top Products
Programming
24
Program this setting using either the base unit or
handset.
Important:
L When the unit receives a call from a number that
is stored in the call barred list, the call is logged
in the caller list (page 26) with 7 after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in the call
barred list by using the caller list or by entering the
numbers directly.
Important:
L It is advised to store the phone number with an
area code in the call barred list.
■ From the caller list:
1 \ (right soft key)
2 {V}/{^}: Select the entry to be barred. i
8
3 {V}/{^}: “Add Bar List” i M
4 {b}
■ By entering phone numbers:
1 8 (middle soft key)
2 {V}/{^}: “Caller Barred” i M i
~
3 Enter the phone number (24 digits max.).
i M
L To erase a digit, press ^.
4 {b}
■ From the caller list:
1 8 (middle soft key)
2 {V}/{^}: “Caller List” i M
3 {V}/{^}: Select the entry to be barred. i
8
4 {V}/{^}: “Add Bar List” i M
5 {ih}
■ By entering phone numbers:
1 8 (middle soft key)
2 {V}/{^}: “Caller Barred” i M i
~
3 Enter the phone number (24 digits max.).
i M
L To erase a digit, press ^.
4 {ih}
Viewing/editing/erasing bar call numbers
1 8 (middle soft key)
2 {V}/{^}: “Caller Barred” i M
3 {V}/{^}: Select the desired entry.
L To exit, press {b}.
4 Proceed with the desired operation.
■ Editing a number:
8 i {V}/{^}: “Edit” i M i Edit
the phone number. i M i {b}
■ Erasing a number:
W i {V}/{^}: “Yes” i M i {b}
1 8 (middle soft key)
2 {V}/{^}: “Caller Barred” i M
3 {V}/{^}: Select the desired entry.
L To exit, press {ih}.
4 Proceed with the desired operation.
■ Editing a number:
8 i {V}/{^}: “Edit” i M i Edit
the phone number. i M i {ih}
■ Erasing a number:
W i {V}/{^}: “Yes” i M i
{ih}
Note for base unit and handset:
L When editing, press the desired dial key to add,
^ to erase.
Registering a unit
Registering a handset to the base
unit
The supplied handset and base unit are pre-
registered. If for some reason the handset is not
registered to the base unit (for example, w flashes
even when the handset is near the base unit), re-
register the handset.
1 Handset:
8 (middle soft key)
2 {V}/{^}: “Handset Setup” i M
= Base unit
Y Handset
= Base unit
Y Handset
TG6451BX(e).book Page 24 Wednesday, July 8, 2009 10:25 AM