Filter
Top Products
Programming
23
Special programming
Alarm
You can set one of 2 different alarm options (once
or daily) at a time for the handset. An alarm sounds
at the set time for 3 minutes.
Important:
L Set the date and time beforehand (page 12).
1 8 (middle soft key)
2 {V}/{^}: “Handset Setup” i M
3 {V}/{^}: “Time Settings” i M
4 {V}/{^}: “Alarm” i M
5 {V}/{^}: Select the desired alarm option. i
M
6 Enter the desired date and month. i M
7 Set the desired time. i M
8 {V}/{^}: Select the desired alarm tone. i
M
L We recommend selecting a different ringer
tone to the one used for outside calls.
9 M i {ih}
L When the alarm is set, E is displayed.
Note:
L You can skip to step 4 by pressing {R/E} in
standby mode.
L To stop the alarm, press any dial key or place
the handset on the charger.
L When the handset is in use, the alarm will not
sound until the handset is in standby mode.
L If you select “Once”, the setting changes to
“Off” after the alarm sounds.
Selecting area codes to be deleted
automatically
In some situations, phone numbers stored
automatically in the caller list (page 26) will include
area codes. If you do not want to dial the area
codes when making calls from the caller list, you
can store the area codes which you want the unit
to delete automatically.
Example: You have stored the area code “123”. If
you make a call from the caller list to the phone
number “123-456-7890”, the unit dials “456-7890”.
1 8 (middle soft key)
2 {V}/{^}: “Base Unit Setup” i M
3 {V}/{^}: “Area Code” i M
4 Enter an area code (5 digits max.). i M
i {ih}
Changing the base unit PIN (Personal
Identification Number)
Important:
L If you change the PIN, please make note of your
new PIN. The unit will not reveal the PIN to you.
If you forget your PIN, contact an authorised
service centre.
1 8 (middle soft key)
2 {V}/{^}: “Base Unit Setup” i M
3 {V}/{^}: “Base Unit PIN” i M
4 Enter the current 4-digit base unit PIN (default:
“0000”).
5 Enter the new 4-digit base unit PIN. i M
i {ih}
Incoming call barring (Caller ID
subscribers only)
This feature allows the unit to reject calls from
specified phone numbers that you do not want to
answer such as junk calls.
When a call is received, the unit does not ring while
the caller is being identified. If the phone number
matches an entry in the call barred list, the unit
sends out a busy tone to the caller, and then
disconnects the call.
Y Handset
“Off”
Turns alarm off. Go to step 9.
“Once”
An alarm sounds once at the set time.
L If you select Arabic as the display language,
enter the desired month and date.
“Daily”
An alarm sounds daily at the set time. Go to
step 7.
Y Handset
Y Handset
TG6451BX(e).book Page 23 Wednesday, July 8, 2009 10:25 AM