Filter
Top Products
Programming
20
Programmable settings
You can customise the unit by programming the following features using the base unit or handset.
Programming by scrolling through the display menus
1
8 (middle soft key)
2 Press {V} or {^} to select the desired main menu. i M
3 Press {V} or {^} to select the desired item in sub-menu 1. i M
L In some cases, you may need to select from sub-menu 2. i M
4 Press {V} or {^} to select the desired setting. i M
L This step may vary depending on the feature being programmed.
L To exit the operation, press {b} on the base unit or {ih} on the handset.
Note:
L In the following table, < > indicates the default settings.
L The current item or setting is highlighted on the display.
Base unit
*1 When the ringer volume is turned off, ~ is displayed and the base unit does not ring for outside calls.
However even when the ringer volume is set to off, the base unit rings at the low level for intercom calls
(page 29).
*2 If you program this setting using the base unit, you do not need to program the same item using the
handset.
= Base unit / Y Handset
Main menu Sub-menu 1 Sub-menu 2 Page
Caller List
W
––26
Ringer Setup
(
Ringer Volume
*1
<Maximum>
–14
Ringtone
<Ringtone 1>
––
Base Unit Setup
>
Display Setup Contrast
<Level 3>
–
Caller Barred
*2
7
–––
TG6451BX(e).book Page 20 Wednesday, July 8, 2009 10:25 AM