Filter
Top Products
Preparation
Setting up the base
unit
Connecting the AC adaptor
and telephone line cord
Connect the telephone line cord until it
clicks into the base unit and telephone
line jack (O). Connect the AC adaptor
cord (I_) by pressing the plug firmly
(O).
• Use only the included Panasonic AC
adaptor PQLV203.
To single-line
telephone
O jack (RJ11C)
(120 V AC, 60 Hz)
Note:
• The AC adaptor must remain
connected at all times. (It is normal for
the adaptor to feel warm during use.)
• The AC adaptor should be connected
to a vertically oriented or floor-
mounted AC outlet. Do not connect
the AC adaptor to a ceiling-mounted
AC outlet, as the weight of the
adaptor may cause it to become
disconnected.
• The unit will not work during a power
failure. We recommend connecting a
corded telephone to the same
telephone line or to the same
telephone line jack using a Panasonic
T-adaptor (page 5).
If you subscribe to a DSL service
Please attach a noise filter (contact your
DSL provider) to the telephone line
between the base unit and the
telephone line jack in the event of the
following:
- Noise is heard during conversations.
- Caller ID features do not function
properly.
le-line
elephone
jack (RJ1 lC)
Noise filter
Setting up the handset
Connecting the AC adaptor
Available model:
KX-TG6072/KX-TG6073/KX-TG6074
• Use only the included Panasonic AC
adaptor PQLV208.
(1_20V AC, 60 Hz)
=
Bottom of the charger
Fasten the AC adaptor cord to
prevent it from being disconnected.
For assistance, please visit http://www.panasonic.com!hetp 9