Filter
Top Products
Programming
22
Programming using the direct commands
1
! i {#}
2 Enter the desired feature code.
3 Press {<} or {>} to select the desired setting. i I
L This step may vary depending on the feature being programmed.
L To exit the operation, press {i}.
Note:
L In the following table, < > indicates the default settings.
*1 If the Caller ID time and date display service is available in your area, this feature allows the unit to
automatically adjust the date and time setting when caller information is received. To use this feature,
set the date and time first.
*2 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up the
handset to answer a call, turn off this feature.
*3 Turn this feature off if you prefer not to hear key tones while you are dialing or pressing any keys.
*4 The flash time depends on your telephone exchange or host PBX. Contact your PBX supplier if
necessary.
Feature Feature code Setting Page
Date and time {0}{0}{1} –12
Dial mode {0}{7}{9} Pulse, <Tone>12
Privacy {1}{9}{4} On, <Off>–
Time adjust
*1
(Caller ID subscribers only)
{2}{2}{6} On, <Off>–
Ringer
(Handset ringer tone)
{0}{5}{4} Tone: <1>–5
Melody: 1–4
15
Ring group
(Handset)
{1}{3}{5} –25
Indiv. call
(Indiv.: Individual)
{1}{3}{6} On, <Off>23
Auto talk
*2
{0}{0}{9} On, <Off>15
Key tone
*3
(Handset)
{0}{5}{8} <On>, Off –
Registration {1}{2}{3} –33
Erase phonebook {1}{4}{4} –19
Night mode {1}{1}{7} On, <Off>24
Hold melody {0}{7}{1} <On>, Off 16
Flash time
*4
{0}{7}{2} <700ms>, 600ms, 400ms, 300ms,
250ms, 110ms, 100ms, 90ms
16
Voice paging {0}{6}{6} On, <Off>28
TG3651BX(e).book Page 22 Monday, May 31, 2010 8:51 AM