Filter
Top Products
74
Troubleshooting
If the handset display shows error messages, see “If the Following Appears
on Your Display...” (p. 72–73) for the Cause & Remedy.
Telephone System
Problem Cause & Remedy
“No link to base. Move
closer to base, try
again.” is displayed and an
alarm tone sounds.
• You are too far from the base unit. Walk
closer to the base unit.
• Confirm the base unit’s AC adaptor is
plugged in.
• Raise the base unit antenna.
• If the above remedies do not solve the
problem, the handset may have lost
communication with the base unit. Register
the handset again (p. 56).
Static, sound cuts in/out, fades.
Interference from other
electrical units.
• Move the handset and base unit away from
other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
The handset and/or base unit
does not ring.
• The ringer volume is turned off. Set to high,
medium or, low (p. 17, 18).
The handset display is blank. • If the only handset display is blank, fully
charge the battery (p. 10).
You cannot program any
function items.
• Programming is not possible while the
handset and/or base unit is being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• While another user is listening to messages
or the Answering System is handling a call,
you cannot program. Try again later.
• When the Dial Lock is turned on (p. 54), you
cannot store the phone number in the phone
book.
While programming or
searching, the handset starts
to ring and the program/search
stops.
• A call is coming in. To answer the call, press
[C], [s] or [SP-PHONE]. Start again from
the beginning after hanging up.