Filter
Top Products
Programmable Settings
14
Date and Time
You need to set the date and time;
— to display the time and date the calls were received in the Caller List, and
— to announce the day and time when each message was recorded, during a
message playback.
• When entering the time in step 3, you cannot enter numbers greater than 12. Do
not use military time. (To set 13:00 hours, enter “0100”, then select “PM” in
step 4.)
To adjust the date and time when
“
E
Press MENU.” flashes on the
handset display:
Press
[MENU], then go to step 3 above.
To confirm the date and time, repeat steps 1 and 2 above.
• The current date and time are displayed. When finished, press [OFF].
1 Press [MENU].
2 Scroll to “Date and time” by pressing [
d
] or
[
B
], then press Select.
3 1 Enter 2 digits each for the day, month, and
year. (Ex. To set May 15, 2004, enter “15
05 04”.)
2 Enter 4 digits for the time (hour and minute).
(Ex. To set 9:30, enter “0930”.)
• If you enter a wrong number, press [
d
] or [
B
] to
move the cursor to the incorrect number. Enter the
correct number.
4 Select “AM” or “PM” by pressing AM/PM.
5 Press Save.
• The date and time are set and “E” disappears
from the base unit display.
• If the handset beeps 3 times, the date and time
were not set correctly. Start again from step 3.
6 Press [OFF].
The date and time may be incorrect after a power failure. When “E” flashes on
the base unit display or “
E
Press MENU.” flashes on the handset display,
adjust the date and time.
Handset
Date and time
Back Select
K
d
BL
Example
Date:
|
31.12.2004
Time:12:00 AM
AM/PM Save
K
L
Date:
|
15.05.2004
Time:09:30 AM
AM/PM Save
K
L
Date:
|
15.05.2004
Time:09:30 AM
AM/PM Save
K
L