Filter
Top Products
Special Features
56
Re-registering the Handset
If “No link to base. Move closer to base, try again.” is displayed
even when using the handset near the base unit, the handset may have lost
communication with the base unit. You need to re-register the handset to the base
unit.
• Make sure the base unit is not being used.
• Have both handsets and base unit nearby during registration.
• Follow steps 1–3 listed below. You have about 1 minute to complete them.
• Confirm the extension number of the handset which has lost the
communication by placing the handset on the base unit or charger.
If you re-register the handset using the other handset’s extension number, the
other handset will not function.
• If the handset beeps 3 times and “Error!!” is displayed, an error occurred. Try
again from step 1.
• You can stop registration by pressing [OFF] on the handset, and pressing
[LOCATOR/INTERCOM] on the base unit.
1 Base unit: Press and hold [LOCATOR/
INTERCOM] until a beep sounds.
• The CHARGE indicator flashes.
2 Base unit: Press the extension number [1]
() or [2] ( ) of the handset
which has lost the communication.
3 Handset: Press and hold [FLASH/CALL
WAIT] until “Handset
Registering” is displayed.
• When registration is complete, a beep sounds
from the handset and the display shows the
number.
• Wait for 20 seconds after registration is
complete while the handset establishes
communication with the base unit.
Handset & Base Unit
Handset
Registering
Handset [1]
Registered
Ex. Extension number 1