Filter
Top Products
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
71
If the Following Appear on Your Display...
The following will be displayed when the unit needs your attention.
Display message Cause & Remedy
Recharge battery • The battery needs to be charged. Recharge the
battery (p. 10).
Charge for 6h • The battery has been discharged. The handset will
not work. Fully charge the battery (p. 10).
No link to base.
Move closer to
base, try again.
• The handset has lost communication with the base
unit. Walk closer to the base unit and try again or re-
register the handset (p. 54).
• Confirm the base unit’s AC adaptor is plugged in.
• Raise the base unit antenna.
Please lift up
and try again.
• A handset button was pressed while the handset
was on the base unit or charger. Lift the handset and
press the button again.
Busy • The base unit and/or another handset is in use. Try
again later.
• The handset you tried to send phone book items to
is in use. Try again later.
• The handset you are calling is too far from the base
unit.
• Another handset is in programming mode. Try again
later.
Error!! • When you tried to re-register the handset, the
handset and base unit could not link for some
reason, such as interference from electrical
appliances. Move the handset and base unit away
from any electrical appliances and try again.
• Another handset tried to send phone book items to
you but the copying stopped (p. 43, 44).
Phone book full • When you tried to store an item in the phone book,
the phone book memory was full. Press [OFF] to exit
the programming mode. To erase other items from
the phone book, see page 42.
System is busy.
Please try again
later.
• The handset has lost communication with the base
unit. Walk closer to the base unit and try again.
• The Answering System is in use, such as answering
a call or playing back messages. Try again later.
• Another handset is in programming mode. Try again
later.
PQQX13991YA.book 71 ページ ２００４年２月２５日 水曜日 午前１１時１２分