Filter
Top Products
Special Features
54
Key Tone
You can select whether or not the handset keys will sound tones (key tone,
confirmation tone, error tone). The factory preset is ON.
Re-registering the Handset
If “No link to base. Move closer to base, try again.” is displayed
even when using the handset near the base unit, the handset may have lost
communication with the base unit. You need to re-register the handset to the base
unit.
• Make sure the base unit is not being used.
• Have both handsets and base unit nearby during registration.
• Follow steps 1–3 listed below. You have about 1 minute to complete them.
• Confirm the extension number of the handset which has lost the
communication by placing the handset on the base unit or charger.
If you re-register the handset using the other handset’s extension number, the
other handset will not function.
• If the handset beeps 3 times and “Error!!” is displayed, an error occurred. Try
again from step 1.
• You can stop registration by pressing [OFF] on the handset, and pressing
[LOCATOR/INTERCOM] on the base unit.
1 Press [MENU].
2 Scroll to “Initial setting” by pressing [
d
] or [
B
], then press
Select.
3 Scroll to “Key tone” by pressing [
d
] or [
B
],
then press Select.
4 Select “Off” or “On” by pressing [
d
] or [
B
].
5 Press Save, then press [OFF].
1 Base unit: Press and hold [LOCATOR/INTERCOM] until a beep sounds.
• The CHARGE indicator flashes.
2 Base unit: Press the extension number [1] () or [2] ( ) of the
handset which has lost the communication.
3 Handset: Press and hold [FLASH/CALL
WAIT] until “Handset
Registering” is displayed.
• When registration is complete, a beep sounds
from the handset and the display shows the
number.
• Wait for 20 seconds after registration is
complete while the handset establishes
communication with the base unit.
Handset
Key tone
Back Select
K
d
BL
Key tone
:On
Back Save
K
d
BL
Handset & Base Unit
Handset
Registering
Handset [1]
Registered
Ex. Extension number 1
PQQX13991YA.book 54 ページ ２００４年２月２５日 水曜日 午前１１時１２分