Filter
Top Products
60
Erasing Messages
The unit will announce the remaining recording time after playback if it is less than
3 minutes.
New messages cannot be recorded when:
—“Memory full” is heard.
—“ ” flashes on the base unit.
—the ANSWER ON indicator flashes rapidly (when the Answering System is on).
Erase unnecessary messages. We recommend you erase unnecessary messages
after each playback.
Erasing a specific message
Press [ERASE] while the message you want
to erase is being played.
• The unit beeps, then plays back the next message.
• To exit playback mode, press [STOP] twice.
Press [*] [4] while the message you want to
erase is being played.
• The unit beeps, then plays back the next message.
• To exit remote operation mode, press [OFF].
Erasing all messages
All recorded messages, except the greeting message, can be erased at one time.
• Information in the Caller List will not be erased. To erase caller information, see
page 37.
1 Press [ERASE] while the base unit is not being used.
•“To erase all messages, press ERASE again” is heard.
2 Within 10 seconds, press [ERASE] again.
• The unit beeps, then announces “No messages”.
• The base unit display shows “0”.
1 Press [MENU].
2 Press Select at “Message play”.
3 Press [*] [5].
• The unit beeps, then announces “No messages”.
• To end remote operation, press [OFF].
FULL
[ERASE]
ANSWER ON Indicator
[STOP]
Base Unit
Handset
Base Unit
Handset
PQQX13991YA.book 60 ページ ２００４年２月２５日 水曜日 午前１１時１２分