Panasonic KX-TG1031 Telephone User Manual


 
Programming
For assistance, please visit http://www.panasonic.com/help 25
*5 This feature allows the unit to automatically adjust the date and time setting when
caller information is received. To use this feature, set the date and time first.
*6 The flash time depends on your telephone exchange or host PBX. Consult your
PBX supplier if necessary. The setting should stay at “700ms” unless pressing
{FLASH} fails to pick up the call waiting call.
Alarm
An alarm will sound once for 3 minutes at the set time. Set the date and time
beforehand (page 15).
1 {MENU}
2 {V}/{^}: “Alarmi Press {OK} 2 times.
3 {V}/{^}: Select the desired alarm mode. i {OK}
4 Set the desired time. i {OK}
5 {V}/{^}: Select the desired ringer tone. i {OK}
L We recommend selecting a different ringer tone from outside call.
6 {V}/{^}: “Savei {OK} i {OFF}
Note:
LTo stop the alarm, press any dial key or place the handset on the base unit or
charger.
LWhen the handset is in use, the alarm will not sound until the handset is in standby
mode.
LIf you select “Once“, the setting will change to “Off“ after the alarm sounds.
LWhen the ringer volume is set to off, the handset rings at the low level for alarm.
Customer support
The handset can display the Internet address where you can download the operating
instructions or get further information for this product using your computer.
1 {MENU}
2 {V}/{^}: “Customer supporti {OK} i {OFF}
Off Turns alarm off. Press {OK} again, then press {OFF} to exit.
Once The alarm sounds once at the set time. Enter the desired date.
Daily An alarm sounds daily at the set time.
TG103x.book 25 ページ 2008年12月3日 水曜日 午後12時58分