Filter
Top Products
71
Chapter 4
Programmable Functions on the Base Unit
Other Feature
with the Handset
Selecting Flash Mode
•Users in Australia can access Telstra’s “EASY CALL” service by having the recall time set at
100msec (this is the factory default setting), and then follow Telstra’s “EASY CALL” instructions to
operate this service.
•If you are connected via a PBX, a longer or shorter recall time may be necessary to use PBX
functions (transferring a call etc.). Consult your PBX supplier for the correct setting.
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press , then enter the 4-digit base
unit PIN (p. 67).
4 Press then
.
1
2
3
5 To select “Flash 1(700msec)”, press .
OR
To select “Flash 2(100msec)”, press .
6 Press .
•A beep sounds.
•To return to the standby mode, press
.
2
1
KX-TCD735ALM(E)-3(50~75) 2002.06.21 5:24 PM Page 71