Filter
Top Products
69
Chapter 4
Programmable Functions on the Base Unit
Input Command
121 3-123456
5 Press .
•The current number of rings is displayed
at the end of the 2nd line.
6 Select the number of rings 1 through 6
with the dialing buttons to , then
press .
•A beep sounds.
•The display will return to “Setting
Base”. To return to the standby mode,
press .
6
1
Selecting the “Selected then All Handsets” Ringer Mode
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press , then enter the 4-digit base
unit PIN (p. 67).
•The current mode is displayed.
4 Press , then select handset
number(s) you desire to ring first.
•The selected handset number(s) blink(s).
Ex. All registered handsets (1 to 6) are
displayed and selected handset
numbers (1 and 5) to ring first blink.
3
1
with the Handset
Key Tones
with the Handset
You can select the base unit keys to sound tones (key tone) or not.
The factory preset is 1 (ON).
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press then .
•The current setting is displayed.
1: ON 0: OFF
1
2
4 Press for ON.
OR
Press for OFF
Ex. 1 (ON) is selected.
5 Press .
•A beep sounds.
•
The display will return to “Setting Base”.
To return to the standby mode, press .
0
1
Input Command
1221517590
KX-TCD735ALM(E)-3(50~75) 2002.06.21 5:24 PM Page 69