Filter
Top Products
52
➡ Before Requesting Help
Problem Remedy
While programming or searching, • To answer the call, lift the handset or
ZO
.
the unit starts to ring and stops • Start again from the beginning after hanging up.
the program/search.
The unit does not display the • Other telephone equipment may be interfering with
caller’s phone numbers. • your phone. Disconnect them and try again.
• Other electrical appliances connected to the same
outlet may be interfering with the Caller ID
information. Telephone line noise may be affecting
the Caller ID information.
Ï
does not function. • The handset is too far from the base unit.
• The handset is engaged in an outside call.
You cannot redial. • If the last number dialled was more than 24 digits
long, the number will not be redialled correctly.
The paged handset does not • The handset is not in the same radio area.
answer. • The handset is engaged in an outside call.
• The handset has been cancelled or has not been
registered. Register the handset in the base unit
(p.36).
While using the intercom, two tones • A call is being received. To answer,
ZP
then
sound. •
O
.
The unit misdials when connected • Check the pause function (p.25).
to a PBX.
You cannot register the handset • The base unit has registered a maximum of 6
in the base unit. • handsets or the handset has registered a maximum
of 4 base units.
• A wrong base unit password was entered. Enter the
correct password.
• There is interference from other electrical units,
locate the handset and base unit away from them.
• You must finish registration within 1 minute after the
ringer tone sounds, or programming will be
cancelled (p.36).
The battery strength is not • Check that the battery type selection is correct
displayed correctly. • (p.34).
30401 English KX-TCD700NL 25/4/01 2:32 pm Page 52