Panasonic KX-TCD700NL Telephone User Manual


 
Registration
• Registering a Handset to a Base Unit (register hs)
The handset supplied with the base unit is already registered. If an optional
handset/base unit is purchased, the following procedure needs to be carried out
before initial use.
Z and Hold Ï on base unit for 10 secs. A confirmation tone sounds.
36
-1-888888800
ÂÊÁËÈÍ
QÏÔÓÒ
(Standby Mode)
new speed
ÂÊÁËÈÍ
ÎÏÔÓÒ
ZYor V
setting hs
ÂÊÁËÈÍ
ÎÏÔÓÒ
ZSor U
ZS
or U
ZY
or V
Z
Y
or V
time alarm
 ÊÁËÈÍ
ÎÏÔÓÒ
registration
 ÊÁËÈÍ
ÎÏÔÓÒ
Z
Y or V
base 2
 ÊÁËÈÍ
ÎÏÔÓÒ
S U
base 4
 ÊÁËÈÍ
ÎÏÔÓÒ
Select base unit.
ZYor V
(Hyphen is moving during
searching).
Connection OK.
Enter PIN (4 digits).
Base is found
On completion of
registration, a
confirmation tone
sounds
If registration is not
successful within 5
minutes, an error
tone sounds and
display returns to
original standby
mode.
ZYor V
(Searching Base).
bs9pin É
 ÊÁËÈÍ
ÎÏÔÓÒ
88-888888888
 ÊÁËÈÍ
QÏÔÓÒ
-2-888888801
ÂÊÁËÈÍ
ÎÏÔÓÒ
register hs
 ÊÁËÈÍ
ÎÏÔÓÒ
S U
cancel base
 ÊÁËÈÍ
ÎÏÔÓÒ
NOTES:
Charge the optional handset batteries for about 10 hours
before initial use.
Register the handset within 1 minute. If not registered
within 1 minute, ZP on the handset to cancel the
programming mode. Then re-start registration.
Calls (both incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio areas overlap
with neighbouring base units).
Note:
To return to the previous step during programming, ZT.
To exit the programming mode at any time, ZP.
See Page 37
30401 English KX-TCD700NL 25/4/01 2:32 pm Page 36