Filter
Top Products
Before Requesting Help ➡
Problem Remedy
The unit does not work. • Turn the power ON (p.12).
• Check the settings.
• Charge the batteries fully (p.7).
• Clean the charge contacts and charge again (p.7).
• Unplug the AC adaptor and turn the power OFF to
reset. Plug in the AC adaptor and turn the power
ON. Then try again.
• The handset has been cancelled or has not been
registered. Register the handset (p.36).
• Re-install the handset batteries and try again.
“
Î
” flashes and an alarm tone • You are too far from the base unit. Move closer and
sounds when you
ZO
. • try again.
• Plug in the AC adaptor.
A busy tone sounds when you • Another handset is in use.
ZO
.
You cannot dial. • The unit is in call prohibition mode. Cancel the mode
(p.33).
• The dialled number is restricted. Cancel the number
(p.44).
• Key lock mode is set. Cancel the mode (p.26).
“
Î
” flashes during a conversation • The handset is out of range. Move closer to the
and the call is disconnected. • base unit and make the call again.
• Plug in the AC adaptor.
Static, sound cuts in/out, fades. • Locate the handset and base unit away from other
Interference from other electrical • electrical appliances.
units. • Move closer to the base unit.
The handset does not ring. • Turn the power ON (p.12).
• The ringer is set to OFF. Select the desired volume
level (p.29).
The base unit does not ring. • The ringer is set to OFF. Set to HIGH, MEDIUM or
LOW (p.41).
You cannot program function items • Programming is not possible while the unit is in the
such as the handset ringer volume. • talk or intercom mode.
• Do not pause for over 60 seconds while
programming.
You cannot store a phone number • You cannot store a phone number while the unit is
in memory. • in the talk or intercom mode.
• Do not pause for over 60 seconds while storing.
51
30401 English KX-TCD700NL 25/4/01 2:32 pm Page 51