Filter
Top Products
Operation
28 User Manual
Calling an external party
You have to seize an outside line before dialling an outside phone number because external calls are
made via your system.
Select one of the following methods:
• Press an idle button.
• Dial automatic line access number (or ).*
An idle line is selected automatically.
*
)
0: [SA], 9: Others
• Dial trunk group access number to .
A specific line is selected.
• The CO button light shows the current status as follows:
Off: The line is idle.
Green on: You are using the line.
Red on: The line is in use.
• Emergency call
You can dial pre-programmed emergency numbers without any restrictions.
• Hands-free operation
To keep your hands free, press the SP-PHONE button instead of lifting the handset. You
can then perform other tasks at the same time.
Helpful hints for hands-free operation
Use your telephone in a quiet room for best performance.
If the other party has difficulty hearing you, decrease the volume.
If you and the other party talk at the same time, parts of your conversation will be lost. To
avoid this, talk alternately.
• To select the less expensive line automatically, dial "0 (or 9)*" or press the Loop-CO
button to seize a line. (Automatic Route Selection)
*
)
0: [SA], 9: Others
• If you misdial, press the FLASH button <PT>; or press the switchhook lightly <SLT>; and
then dial the number again. The line will remain engaged.
(
CO
)
9
8
0
1
8
4
8
Off-hook.
Talk.Enter phone number.
Seize an external line
(CO, 0 (or 9)* or 801-848).
phone no.
PT / SLT
OR
to
OR
(CO)
D.Tone
0
1
4 8
0
8
8
*) 0: [SA], 9: Others
(or
9 )*