Filter
Top Products
Answering Device
Remote Operation
Notice of Remote Operation
Fold here
1.
Call your unit.
2.
Enter the remote operation ID
during the greeting
message.
●
The new messages will be
played automatically.
●
If there are no new
messages, wait for 4
seconds. All the messages
will be played back.
3.
Press the remote command
key(s) within 10 seconds (see
the reverse side).
●
The remote operation is
available only from a touch
tone telephone when the unit
is in the TAD/FAX mode.
●
When the unit is in the TEL
mode, call your unit and wait
for 10 rings. Enter the remote
operation ID within 8 seconds
and wait for 3 seconds. The
unit will switch to the TAD/FAX
mode.
●
When you press a key, press
firmly.
●
To send a document, press
. When a fax tone is
heard, start transmission.
9
59
Remote Operation
(KX-FP185 only)
The following operations can be performed from a remote location using a touch tone telephone.
Program the remote operation ID (feature #11 on page 66) and set the unit to the TAD/FAX
mode before going out (p. 52).
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
Operating from a remote location!
Note:
●
During remote operation, the unit will stop and two beeps will be heard in the following conditions:
— 2 minutes 40 seconds after your unit answered.
— Every 2 minutes 40 seconds after pressing any command key.
To listen to further messages, press within 10 seconds after hearing the two beeps.
8
Stops re-recording of a greeting
message
Erases a specific message
Erases all messages
Changes to the TEL mode
Turns ON message transfer
Turns OFF message transfer
Turns ON pager call
Turns OFF pager call
Remote command
Dial key
Page
Dial key
Remote command Page
Skips the greeting message
Repeats a message
Skips a message
New message playback
All message playback
Re-records a greeting message
Continues operation
61
60
60
60
60
61
See
note
84
83
82
81
80
5
4
9
61
61
61
61
61
61
61
61
8
7
5
4
2
1
0