Oregon Scientific OS6976 Cordless Telephone User Manual


 
EN
5. Press CID VOL(+) arrow key to blink the next digit.
6. Continue entering digits for the number of seconds you want to set.
NOTE: Maximum timing period is 99 minutes 99 seconds, while one minute equals 60
seconds.
When the countdown time is set,
1. Press the timer button to start counting down. You will hear a confirmation tone.
2. When the countdown time expires,
TIMER ON 00 MIN 00 SEC
shows in the display, and an
alarm sounds for two minutes.
When the phone is OFF (not in TALK mode), press the TONE*/exit button (handset) or the EXIT
button (Kitchen Companion) to stop the countdown and return to standby mode.
NOTE: The handset timer stops automatically if the battery charge is low or empty.
Press the timer button to pause the countdown. The remaining time is held. Press timer again to
resume the countdown.
Once the countdown starts, the timer keeps counting down until time runs out and the alarm
sounds even if the phone is in other modes. To cancel the timer while in other modes, press
TONE*/exit or timer. The timer does not show in the display in other modes. To view the
remaining time, press the timer button.
1. Press the timer button to view the remaining time, and press timer again to display the channel
number, call counter, and volume level.
2. When the countdown is complete,
TIMER STOP
shows in the display, and an alarm sounds for
two minutes.
3. Press the timer button to stop the alarm and display the channel number, call counter, and
volume level.
NOTE: You cannot stop a countdown when the phone is ON (in TALK mode).
NOTE: To maximize the countdown timer's functionality, ensure the battery is fully
charged.
STARTING THE TIMER
STOPPING THE TIMER
PAUSING THE TIMER
USING THE TIMER WITH OTHER MODES
TALK MODE
34
os6976-en1.p65 5/20/2005, 12:09 PM37