Filter
Top Products
EN
The ringer must be ON for the handset to ring during incoming calls. Refer to the Ringer Setup
section for instructions on turning on the ringer.
While talking, press the volume buttons (left and right arrows) to adjust the listening level of the
handset's earpiece. There are four volume levels. Press the right arrow (+) button to increase the
volume level, and press the left arrow (-) button to decrease. VOL 1 is the lowest level and VOL 4 is
the loudest.
While you are talking on the phone, the total talk time is displayed on the bottom line of the
display.
For best speakerphone performance, avoid the following:
• Areas with high background noise. (The microphone might pick up these sounds and prevent
the speakerphone from going into the receiving mode when you finish talking.)
• Surfaces affected by vibration.
• Recessed areas such as in a corner, in a cupboard, or next to a cabinet, which can generate an
echo effect.
• The speakerphone works similar to a two-way radio, you can only listen or talk at one time.
• Stay reasonably close to the phone so that you can be clearly heard by the person to whom you
are talking.
• Press the speaker button to turn on the speakerphone.
• Press the CID VOL(+) or CID VOL(-) arrow button on the Kitchen Companion to adjust the
speakerphone listening level. You will hear a tone when you reach the minimum or maximum
volume level.
The Kitchen Companion is pre-registered to the wall base unit.
If your Kitchen Companion is properly connected, but you cannot hear a dial tone when pressing
the SPEAKER button, it may not be properly registered. Then, follow these steps to re-register the
Kitchen Companion to the wall base unit:
1. Move the Kitchen Companion close to the wall base unit or vice versa.
2. Make sure both the handset and the Charge speakerphone are OFF (not in TALK mode).
RINGER
VOLUME
CALL TIMER
SPEAKERPHONE OPERATION
SPEAKERPHONE LOCATION
SPEAKERPHONE GUIDELINES
REGISTRATION
22
os6976-en1.p65 5/20/2005, 12:09 PM25