Filter
Top Products
EN
A built in antenna is used for AM reception.
The power cord acts as the FM antenna. For best reception, be sure the power cord is stretched to its
fullest length. Do not coil or bunch the cord together. Changing the position of the power cord may
improve reception.
Use the radio on/off button to turn the radio on or off.
Use the AM/FM button switch to select which broadcast band you want the radio to receive.
Use the CID VOL(+)/CID VOL(-) button to adjust the radio volume. The display shows the current
volume setting.
Use the tune/seek (+) / tune/seek (-) up down arrow buttons to change the radio station. If you hold
down either button, the radio automatically scans for radio stations.
When a radio station is tuned in, press and hold the preset button until the unit beeps and a
memory location displays, then select the preset number using the skip and rev buttons. Finally,
press the preset button to save the radio station. Up to five (5) AM in addition to five (5) FM radio
stations may be stored.
To listen to a preset radio station on the current band, press the preset button to enter the
selection mode, followed by the skip or rev button to select a preset station.
When you are listening to the radio, the clock (time of day) shows in the upper left corner of the
display.
AM ANTENNA
FM ANTENNA
TURNING ON THE RADIO
BAND
RADIO VOLUME
CHANGING STATIONS
STORING PRESET STATIONS
USING PRESET STATIONS
CLOCK
RADIO OPERATION
30
os6976-en1.p65 5/20/2005, 12:09 PM33