Filter
Top Products
EN
Set your phone according to the type of service you are subscribed to.
1. Press flash/program button until
SET TONE/PULSE >TONE PULSE
shows in the display.
2. Use the CID VOL(+) / CID VOL(-) arrow keys to select
TONE
or
PULSE
.
TONE
is the default.
3. Press the flash/program button to store (if a change is made, you will hear a confirmation tone).
If you prefer to use the system’s original settings, follow the steps below to return the answering
system to the factory default settings.
1. Press flash/program button until
DEFAULT SETTING YES NO
shows in the display.
2. Use the CID VOL(+) / CID VOL(-) arrow keys to select
YES
or
NO. NO
is the default.
3. Press the flash/program button to confirm.
4. If you select
YES
, you will hear a confirmation tone, and the handset resets to the following
default values:
LANGUAGE ENGLISH
LOCAL AREA CODE - - -
TONE/PULSE DIALING TONE
The handset and the Kitchen Companion are pre-registered to the wall base unit. If your handset is
properly connected, but you cannot hear a dial tone when pressing the TALK button, it may not be
properly registered. Follow these steps to re-register the handset to the wall base unit:
1. Make sure both the handset and Kitchen Companion speakerphone are OFF (not in TALK mode).
2. Press and hold the format button on the handset until you hear a beep and
PRESS AND HOLD
BASE PAGE KEY
shows in the display.
3. Move the handset close to the wall base unit.
4. Press and hold the page button on the wall base unit.
NOTE: You must press the page button on the wall base unit within 30 seconds to
continue registration.
5. You will hear a confirmation tone when the registration is complete, and the handset’s display
shows
REGISTERED
.
TONE/PULSE DIALING
DEFAULT SETTINGS
HANDSET OPERATION
REGISTRATION
19
os6976-en1.p65 5/20/2005, 12:09 PM22