Filter
Top Products
Page 69
P0906186 Issue 02 Compact ICS 4.1 Programming Record
Software Keys
In this section, you can access optional features and services.
SysID
This number can be viewed on any M7324 or M7310 telephone display. Record the number,
which you will be asked to provide when you call the Nortel Customer Response Center.
Password Keys
The keys are obtained by calling the Nortel Customer Response Center at 1-800-321-2649.
The keys are required for some system expansion activities and to activate the remote
monitoring capability.
Key 1
Enter the eight-digit password.
Key 2
Enter the eight-digit password.
Key 3
Enter the eight-digit password.
Hardware
In this section, you can view and configure the Trunk Cartridges and BRI Cards installed in the
ICS.
Cd1-KSU
Configure the cartridge or card that occupies the left-most slot in the ICS.
Card type
The display shows the current card type.
Lines
View the line-number range for the lines on an LS/DS or CI Analog Trunk Cartridge.
Discon timer
Specify the duration of an Open Switch Interval for an LS/DS or CI Analog Trunk Cartridge.
Loops
View the loops on this BRI Card.
Loop
View the settings for a particular loop on this BRI Card.
Type
View or change the loop type.
Lines
View the lines on this loop (only for S, T, and U-NT loops).
No SPIDs assignd
Assign one or two service profile identifiers (SPIDs) as supplied by your service provider. SPID
settings appear only for S, T, and U-NT loops.
SPID1
Enter the SPID supplied by your service provider.
# of B-channls
Select the number of B-channels that are associated with the SPID.
Network DNs
Enter the Network DNs that are associated with the SPID.
Call type
Select the Call type used with the Network DN. For each Network DN, use only one of each of
the Voice and Data call type settings, or a single Both call type setting.
SPID2
Enter the second SPID supplied by your service provider, if applicable.
D-packet srvce
Configure the D-packet service for this loop.
D-packet srvc
Turn the D-packet service for this loop on or off.
Lp201
Select the S-loop (for BRI-ST Card) or U-LT loop (for BRI-U2 or BRI-U4 Card) that supports the
D-packet service.
TEIs
Add up to eight Terminal Endpoint Identifiers (TEIs). Each TEI is supplied by your service
provider and is associated with an ISDN device.
No TEIs on loop
Enter the two-digit TEIs supplied by your service provider.
ONN blk
Determine the ONN blocking for BRI loops.
Sampling
Select the sampling used by an S loop.
DNs on Loop 201
Assign the ISDN DNs that use this S loop or U-LT loop.
Assign DNs
Enter up to seven ISDN DNs for each S loop or U-LT loop.