Filter
Top Products
Page 62
Compact ICS 4.1 Programming Record P0906186 Issue 02
Show DstCode:_
Up to 500 destination codes are programmable.
Enter the digits (up to 7 digits) of the destination code that you want to define. No two
destination codes can be identical. A destination code cannot begin with a digit assigned as
the Call Park prefix, or a Direct-dial digit. It cannot be the same as, or be the start digits of a
DN, the DISA DN or the Auto DN, a line pool code, or a received number.
Normal
For the last destination code, define the normal service. You will usually use the route that has
the lowest cost for the times when normal service is in use.
AbsorbLength
Enter the number of digits from the destination code that will not be dialed as part of the
outgoing number.
Night
Evening
Lunch
Sched 4
Sched 5
Sched 6
For this destination code, define a route for each of the schedules, as you have done for normal
service.
Sched:Night
This schedule can be activated automatically or manually, or it can be left in the default Off.
Service
Select how you want this service activated, if applicable.
Overflow
For each schedule, choose whether you want a destination code to use the route assigned to
normal service when the route assigned to the schedule is busy.
Sched:Evening
Sched:Lunch
Sched:Sched 4
Sched:Sched 5
Sched:Sched 6
Select how you want each of the scheduled services to be activated, and whether a destination
code uses the route used with normal service when the route used with the schedule is busy.
Common settings
In this programming section, you can assign settings that are shared by different services.
Control sets
Assign control telephones to turn services on or off.
For lines
Select a control set for each line.
Show line:_
Enter the number of the line you want to program.
L001
Assign a control telephone to each external line. This telephone is where you turn services on
and off for the line.
For sets
Select a control set for each set.
Show set:_
Enter the number of the telephone you want to program.
<internal #>
Assign a control telephone to each telephone. This telephone controls Restriction service and
Routing service for the set.
Schedule names
The schedule name is shown on the display of the control telephone when the schedule is turned
on. It identifies the active schedule.