Nortel Networks ICS 4.1 Telephone User Manual


  Open as PDF
of 77
 
Page 67
P0906186 Issue 02 Compact ICS 4.1 Programming Record
••• Fax Switch
Select whether the Fax detection switch is active or not with the Auto Attendants Custom Call
Routing feature. The default is set to Off.
• Fax DN
Enter the DN of the fax machine that functions with the Auto Attendants System Answer or
Custom Call Routing feature, when the Fax switch detection is active.
 Remote access
In this programming section, you can create a system of controlled access to your Norstar
system.
 Remote access pkgs
Create packages to apply to lines that allow or restrict the remote access to Norstar line pools,
paging, and remote administration.
 Show pkg:_
Enter the two-digit remote package number (00-15). Package 00 is pre-set to allow no access.
 LinePool access
For each package, select whether the user will have access to your systems line pools.
 Pool <pool letter (pool
code)>
For each line pool, select whether a remote user can have access.
 Remote page
For each package, select whether a remote user can access the Page feature.
 Remote admin
For each package, select whether a remote user can see and change programming.
 Remote monitor
For each package, select whether a remote user can monitor the system.
 Rem line access
Select the remote access packages to be applied.
 Show line:_
Enter the line number.
 IRAD
Program a line to be automatically answered by the I-RAD after a set number of rings.
 Answer line
Any line that is programmed to be manually answered (including target lines), and that is not
answered by CCR, can be programmed to answered by the I-RAD.
 After
Select the number of times the line will ring before I-RAD will answer.
 Recd # length
Select the number of digits received on auto-answer lines. These digits are used to identify the
Auto DN and DISA DNs, and to route calls to target lines.
 DN length
Select the length of DNs. DN length can be three to seven digits. Each increase in DN length
adds the digit 2 to an existing DN (for example: DN 344, increased to five digits becomes
22344).
 Natnl length
The length of the telephone number dialed to reach a person within the same country.
 Make/Break:
Select the Make/Break ratio. The default Make/Break ratio is 40 / 60.
 Release reasons
Release reasons.
 Internal modem
Setting for internal modem when used for remote administration.
 Alarm reporting
Set up the system to automatically transmit alarm codes using the I-RAD.
 Auto report
Turn automatic alarm reporting on or off.
 Phone #1
Enter the telephone number the system will dial to transmit an alarm code.
 Phone #2
Enter an additional telephone number the system will dial to transmit an alarm code.
 Use line
Enter the number of the line the system will use to transmit an alarm code.
 Retry time
Enter the length of time in minutes the system will wait before retrying a telephone number used
for transmitting alarm codes.
 Num. retries
Select the number of times the system will retry its transmission of an alarm code.
 Hospitality
Hospitality services programming.
 previous next