Filter
Top Products
Page 57
P0906186 Issue 02 Compact ICS 4.1 Programming Record
HF answerback
Select whether a user can automatically answer a voice call without lifting the receiver or
pressing the Handsfree/Mute button. This setting is always turned off for an M7100 telephone.
Pickup grp
Select one of four pickup groups to which the telephone will belong. Any user in a pickup group
can answer calls to any other telephone in his or her group using the Call Pickup - group feature
(ÄàÞ). Choose None to disable the feature for this telephone.
Page zone
Select one of three page zones to which this telephone will belong. Choose None to prevent
pages at this telephone.
Paging
Select whether paging announcements can be made from this Norstar telephone.
D-Dial
Select whether you can call the Direct-dial telephone from this telephone using the Direct-dial
digit.
Priority call
Select whether to allow this telephone to interrupt calls or to override Do Not Disturb at another
Norstar telephone. A priority call (Äßá) can be refused by the person whose call
you are trying to interrupt by using Do Not Disturb (Ä¡Þ). A priority call cannot be
blocked by a person whose telephone is already in Do Not Disturb.
Hotline
Select whether a telephone number will be dialed automatically when a user lifts the receiver or
presses ©. Choose Intrnl to enter an internal Norstar telephone as the hotline. Choose
Extrnl to enter an external telephone as the hotline.
Aux. ringer
Select whether an auxiliary ringer (if installed) will ring for incoming calls at this telephone.
Allow redirect
Select whether to allow lines at this telephone to be redirected.
Redirect ring
Select whether a telephone rings briefly when a call on one of its lines is redirected by the Line
Redirection feature (Ä¡Ý).
ATA settings
Programming settings which are used with an analog terminal adapter (ATA) or the internal
analog terminal adapter (I-ATA).
ATA ans timer
Select the delay between the last digit you dial on a device connected to an ATA and when the
analog device is ready to receive DTMF tone from the far end analog device.
Use ringback
Select whether the I-ATA detects ringback or waits a pre-programmed number of seconds
before the call is connected.
ATA use
Select whether or not the device attached to the ATA is an off-premise extension (located off
site) or located in the same place as the ICS. This setting is not available for the I-ATA.
Name
A programming section that lets you assign names (up to 7 characters long) to telephones.
User prefernces
A programming section that lets you program the user features, such as external autodialers,
language choice and display contrast, which personalize the operation of the users set.
Model
Allows you to pre-program the model of Norstar set which will use this DN.
Button prgrming
Lets you program the buttons with internal and external autodialers and/or programmed
feature keys.
User speed dial
Section where user speed dialers can be programmed.
Call log optns
Select whether the set will log all calls, no calls, or only unanswered calls.
Dialing optns
Select standard dial, pre-dial or automatic dial.
Language
Choose the display language: English, French or Spanish.
Display cntrst
Select a display contrast level.
Ring type
Select a ring type.
Restrictions
Lets you create and assign restriction filters which prevent a user from making certain kinds of
calls from a telephone, and copy the restrictions from this set to other sets.