Filter
Top Products
dmc3-4
www.mssystems.com | 800.421.1587 | www.mssystems.com
Page 14
DMC1HRWS. This is a surface mount box and cover that will support
the DMC1RW, DMC3RW or DMC4RW patio speakers.
To install a patio speaker follow the instructions presented above for
interior room stations.
Door Stations
Remove the old door station but do not
remove the rough-in box or surface mount
box. When replacing a NuTone door
speaker you must use the DMCFD finish-out
frame. The M&S door station sets in the
DMCFD and the screws attach to the
existing rough-in. Connect the door station
with the corresponding color wires. Screw
the door station or door station with
DMCFD frame into the rough-in box as
shown in Figure 9
External Music Source
The DMC retrofit system supports the use of external music sources.
You can use an existing connection or run a new wire to support local
source connection. To install a new local source follow the steps
detailed in the following paragraphs.
Choose a location for the AWP that will be easily accessible to the
sources that are to be connected to the system (close to the receiver,
TV or DVD player for example). Note: the external source wire run to
the dmc3-4 must not exceed 50 feet.
At this location, attach a single gang box to a wall stud at a center
height of normal wall outlets. Use a low voltage plaster ring in existing
construction installations.
Figure 9 - DMCFD and Door
Station Installation
$QEG$QEG 1.1.