Filter
Top Products
dmc3-4
www.mssystems.com | 800.421.1587 | www.mssystems.com
Page 13
Figure 8 - Placing
Room Station in
After connecting the room station to the existing
wiring using the diagrams above. Place the room
station through the DMCFR plastic mounting
plate. Position the plate either vertically or
horizontally depending on the room station
replaced. Place the room station into the rough-
in ring and align the frame with the room station
as shown in Figure 8. Use the screws provided
with the room station to screw the room station
and frame into place. The holes in the room
station align with the holes in the mounting
plate. The room station keeps the plastic frame
in place on the wall.
Note the plastic frames are paintable. Please
prime the plastic first and then apply standard
room paint. The white plastic may require two coats of paint to get full
coverage. It is recommended that you paint the frame prior to
mounting it to the wall.
Important: Please label all cables at both ends. Incorrectly connecting
cables to the master, room stations or door stations could result in
system damage.
Patio Speakers
Do not remove the existing patio speaker rough-in. The DMC retrofit
system is designed to fit into the existing enclosure. It is important to
note that M&S patio speakers are weather resistant not water proof.
M&S speakers should not be located in an area that is in direct line of
water from sprinklers, rain or other devices such as power washers.
Please use the DMCFRW finish-out frame in outdoor and high sun
areas. The DMCFRW plastic is designed to withstand sun and resist
fading. If a patio requires a surface mount application use the
$QEG$QEG 1.1.