Filter
Top Products
4. Follow steps 4-7 as described in the section Storing Telephone Numbers Into Memory
to overwrite the selected entry.
MIXED MODE DIALING (Temporary Pulse to Tone Dialing)
1. If you only have pulse (rotary dialing) service in your area and want to access Tone
services (Bank by Phone, etc.), ensure that the T / P (Tone / Pulse) switch is set to the
Pulse position.
2. Press the TONE ( * ) button once to switch from Pulse to Tone dialing temporarily.
Pulse dialing mode resumes when the call is ended.
PAUSE FUNCTION
In some cases, such as PABX or long distance service, a pause may be needed in the
dialing sequence. Pressing the RE/PA button inserts a four-second delay between dialed
numbers.
FLASH FUNCTION
Used to access custom calling features such as Call Waiting or Three-Way Calling provided
by your local phone company. Flash can also be used to restore a dial tone to make a new
call.
CHANNEL SELECTION (40 Channels)
A. AUTO CHANNEL SCAN
When you place or receive a call and handset TALK button is pressed, the unit auto-scans
for a clear channel.
Once it finds a clear channel, the handset LCD Display symbol will light steadily.
B. MANUAL CHANNEL SCAN
If the existing channel becomes noisy or starts having
interference, you can either move closer to the base unit
or press the SCAN/PRG button on the handset until better
reception is found.
OUT OF RANGE WARNING
The handset and base unit communicate up to a certain maximum
range. The distance can be affected by weather, power lines, or even
other cordless telephones.
If you are far away from the base unit, the handset beeps and "OUT OF RANGE" is shown
on the LCD display to warn you that the background noise level is too high for proper
communication between the handset and the base unit.
When you hear this sound and see the "OUT OF RANGE" display, you should move closer
to the base unit. Otherwise, the call will automatically cut off after 30 seconds.
LOW BATTERY WARNING
When the handset battery voltage level is low, the handset symbol is shown on the
LCD Display. Return the handset on the base cradle to charge.
PAGING FUNCTION
If you have misplaced the handset or need to alert the person nearby
the handset, press the PAGE button on the base unit. Each press of
this button will activate the handset to beep for 30 seconds and LCD Display shows "BASE
CALL" while it is being paged by the base unit.
NOTE: Even if the handset is in RING OFF mode, the base unit can page the handset.
OUT OF RANGE
BASE CALL
16
(Figure 16)
LOW
MPH7895/04281A(English).put 7/5/01, 4:08 PMPage 17 Adobe PageMaker 6.5C/PPC