Filter
Top Products
13
7. After two beeps, press 1 for AM, or press 2 for PM. The unit will announce the new
day and time followed by a long beep and will prompt "Please enter next command."
8. Press the REMOTE button to exit the remote mode. Otherwise, the remote function
will turn off automatically if not in use for 8 seconds.
TONE / PULSE SETTING
Select the appropriate dialing service by moving the T / P
(Tone / Pulse) switch on the bottom of the base unit:
••
••
• (T) TONE for Tone service, or
••
••
• (P) PULSE for Rotary service.
SETTING THE HANDSET RINGER
The handset ringer must be set to ring ON mode in order that to ring when receiving an
incoming call. See PROGRAMMING MODE section on page 25.
SETTING USER'S AREA CODE AND NEIGHBORING AREA CODE
In order to use callback function, the user's area code and neighboring area code must be
programmed. Neighboring area code is optional. See PROGRAMMING MODE section on
page 24.
SETTING THE CALLER ID CALL WAITING (CIDCW) FUNCTION
The CIDCW function must be set to ON position in order to use CIDCW function. See
PROGRAMMING MODE section on page 24.
TELEPHONE OPERATION
TO PLACE A CALL IN TALK MODE
1. Press the TALK button on the handset. The LCD Display
will show "TALK" and the symbol will flash while the unit
auto-scans and will light steadily when it finds a clear channel.
2. Listen for a dial tone.
3. Dial the telephone number. The phone numbers appear on the LCD Display as you
enter the number.
4. When finished with your call, press the TALK button or place the handset on the
base unit.
TO PLACE A CALL IN STANDBY MODE (PREDIAL MODE)
1. Ensure that the unit is in standby mode.
2. Dial the telephone number or press RE/PA button. If you
make a mistake, press VOL /
button to delete
the character on the left of the cursor.
3. Press C. BACK button.
4. When finished with your call, press the TALK button or place the handset on the base
unit.
TO RECEIVE A CALL
NOTE: If you are expecting incoming calls, the handset must be programmed to RING ON
mode. See PROGRAMMING MODE section on 25.
A. IF THE HANDSET IS ON THE BASE UNIT
1. Since the unit features "Auto-Answer", simply pick up the handset from the base cradle
when the phone rings. The LCD Display will show "TALK" and the symbol will light
steadily.
2. Start your conversation.
3. When finished with your call, either press the TALK button or place the handset on the
base unit.
(Figure 12)
T / P
(Figure 13)
(Figure 14)
MPH7895/04281A(English).put 7/5/01, 4:07 PMPage 14 Adobe PageMaker 6.5C/PPC