Filter
Top Products
12
HANDSET BATTERY INSTALLATION
CAUTION:
Use only the Nickel Cadmium (Ni-Cd) battery type included with this unit. Use of other
battery types may cause injuries or damage.
1. Remove the battery compartment cover of the handset. Connect the rechargeable
Ni-Cd battery as shown in Figure 10.
Line Cord
Telephone
Modular Jack
AC Outlet
9VAC Adapter Jack
AC Plug
9VAC Adapter
(Figure 9)
Insert the End of the
Battery Pack Wire
BLACK Wire
RED Wire
(Figure 10)
2. Insert the Ni-Cd battery into the battery compartment of the handset.
3. Slide the battery compartment cover firmly in its closed position.
INITIAL SETUP
Before you can use your cordless telephone, the handset must be charged for at least 20 hours.
See charging instruction on MAXIMIZING BATTERY LIFE section of this manual.
SETTING THE DAY AND TIME OF THE BASE UNIT
NOTE: The time set is used for time stamping the recorded message(s).
1. After 20 hours, lift the handset from the base unit.
2. Press the REMOTE button on the handset. The unit
will prompt "You have no new message. For help, press
9." followed by a long beep.
3. Press 2. The unit will prompt "Time is off. Enter new day."
4. After hearing a long beep, enter the new day (Sunday = 1, Monday = 2, Tuesday = 3,
etc.). The unit will then prompt "Enter new time."
5. After hearing a long beep, enter the new hour (01-12).
6. After two beeps, enter the new minute (00-59).
Handset
Battery
Compartment
(Figure 11)
MPH7895/04281A(English).put 7/5/01, 4:07 PMPage 13 Adobe PageMaker 6.5C/PPC