Filter
Top Products
Programming
Issue 2 July 1997
3-3
To begin programming, press
3
until the first parameter (“Set
Phone Number?” ) is shown on the display. If your system
administrator preprogrammed your Remote Module, press
2
to
begin system operation (see Chapter 4, Operating the DEFINITY
Extender.)
Setting the Telephone Number
If your Remote Module is connected to a standard telephone line, a
telephone number to dial must be programmed for proper
operation. If your system administrator has not preprogrammed this
telephone number for your Remote Module, follow the steps and
screens below to set the telephone number on the module. The
following screen appears only if the module is configured for
dial
line
operation (DIP switch 2 is OFF). This parameter programs the
telephone number used to call the Switch Module. Ask your system
administrator for the telephone number to program.
1. Press
2
to select this parameter, or press
3
to advance to the
next programming option. If you select
2
, either a screen
appears showing the current stored number or a blank screen
appears if no number has been programmed.
2. To change an existing number or to enter a new number, dial
the required digits by using the telephone keys (0 to 9).
3. Press the Drop button on the display telephone to accept the
number and return to the main menu.