Filter
Top Products
Installation
Issue 2 July 1997
2-5
Table 2-1. DIP Switch Configuration
Switch # OFF ON
1 Normal operation Reserved
2 Normal operation Dedicated lines
3 Normal operation Reserved
4 Normal operation Test mode
NOTE:
If you are using a standard central office line, you do not have to
change the factory-set DIP switches. Check with your system
administrator before making any changes. Your system
administrator may have changed DIP switch 3 to the ON
position for normal operation.
Do not
change this setting without
contacting your system administrator.
2. Connect one end of the line cord provided with the Remote
Module to the telephone company phone jack and the other end
to the LINE jack of the Remote Module.
3. Connect the DEFINITY telephone to the PORT jack of the
Remote Module by using the cord provided with the telephone.
!
CAUTION
:
Do not plug the line cord provided with the Remote Module
into the PORT jack of the Remote Module. Damage to
circuits may result.