Filter
Top Products
11
Door Station Rough-In
VMC1VDS Door Station Rough-in
The VMC1VDS is a metal door station with a 90 degree
horizontal viewing area. It is normally mounted at a height
from the fl oor of: 55” – 60”. When installing the VMC1VDS be
aware of the camera location and the direction of sunlight and
other ambient light. Direct sun or lighting into the lens of the
VMC1VDS camera may impact the video quality. Additionally,
exposure to extreme weather conditions is not recommended.
For added protection against weather, the VMC1VDS should
be equipped with a VDSWS-T weather shield. The installation
of the VDSWS-T is shown in Figure 4.
✓ NOTE: When removing allen screw from Video Door Station front bezel, a
small metal tab will drop out of the chassis. Be sure to re-install tab into
camera chassis slot before re-assembly.
Figure 4. VMC1VDS Door Station Rough-In
1. Identify the location where the VMC1VDS is to be
installed.
2. Pull Cat-5 wire from the VMC1MB to this location.
3. Label and tie off the wires so they do not fall back into the
wall and are accessible when the VMC1VDS is installed.
4. If the door strike or Chime activated Control Output is
to be utilized, see “Door Release Rough-in” and “Chime
Activated CO Rough-in”.
DRYWALL
ANCHORS
CAMERA
CHASSIS
PLEXIGLASS
WEATHER
SHIELD (OPTIONAL)
BEZEL
ALLEN
SCREW
MOUNTING
HEIGHT
FROM FLOOR
LINE
NOTE: METAL TAB
DROPS OUT WHEN
REMOVING ALLEN
SCREW HOLDING
FRONT BEZEL
TO CAMERA CHASSIS
4-1/2’ to 5’-0”
VMC1VDS
VDSWS-T