Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
2
PREPARATION
2 Slide the battery pack along the back of the
transceiver until the release latch on the base of the
transceiver locks the battery pack in place.
3 To remove the battery pack, push up the release
latch, then slide the battery pack back.
BATTERY OPERATING TIME
The following table shows the approximate battery life
(hours) relative to the transmit output power.
PB-38 NiCd
Batteries
UHF Band
VHF Band
Alkaline
PB-39 NiCd
HI LO EL HI LO EL
4.5
3.5
14
10
8
28
13
14
40
4.5
3.2
14
8
7.2
27
12
14
30
INSTALLING THE NiCd BATTERY PACK
Note:
Because the battery pack is provided uncharged, charge the
battery pack before using it with the transceiver. For the method of
charging the battery pack, refer to “CHARGING THE NiCd BATTERY
PACK” {page 43}.
1 Position the two grooves on the inside bottom corners
of the battery pack over the corresponding guides on
the back of the transceiver.
Guide
Release latch
Release latch