Filter
Top Products
19
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
RECALLING MEMORY CHANNELS
1 Press [MR] to enter Memory Recall mode.
• The memory channel used last is recalled.
2 Turn the Tuning control to select the desired memory
channel.
• You cannot recall empty memory channels.
• To restore VFO mode, press [VFO].
You may want to recall only memory channels that store
frequencies of the current band. Access Menu No. 2
(MR) to select “ONE”. The default is “ALL”.
ONE: Recalls only memory channels of the current
band.
ALL: Recalls all programmed memory channels. For
example, allows you to recall a VHF frequency
channel when operating the UHF band.
Note:
◆
You can also recall memory channels by directly entering numeric
keys. See “Memory Channel Number Entry” {page 40}.
◆
When you recall an odd-split memory channel, “+” and “–” appear on
the display. Press
[REV]
to display the transmit frequency.
◆
After recalling a memory channel, you may program data such as
Tone or CTCSS. These settings, however, are cleared once you
select another channel or the VFO mode. To permanently store the
data, overwrite the channel contents {page 18}.
CLEARING MEMORY CHANNELS
1 Recall the desired memory channel.
2 Switch OFF the power to the transceiver.
3 Press [MR]+ POWER ON.
• A confirmation message appears.
4 Press [MR] again.
• The contents of the selected memory channel are
erased.
2
1