Filter
Top Products
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
48
CONNECTING EQUIPMENT FOR REMOTE CONTROL
Make connections as shown when remotely controlling
equipment.
Note 1:
Voltage is developed across the 100
Ω
resistor in the 3.5 V line
in the transceiver. When 2 mA flows, approximately 3.3 V is
developed.
Note 2:
A 10
µ
F capacitor is not required in the following cases:
•
When the other equipment has DC blocking capacitors.
•
When a 2-terminal electret condenser microphone is used.
CONNECTING OTHER EXTERNAL EQUIPMENT
When connecting an external speaker, an external
microphone, or other equipment such as a TNC for
packet radio to the SP jack or MIC jack, refer to the
diagram below.
Note 1:
Voltage is developed across the 100
Ω
resistor in the 3.5 V line
in the transceiver. When 2 mA flows, approximately 3.3 V is
developed.
Note 2:
A 10
µ
F capacitor is not required in the following cases:
•
When the other equipment has DC blocking capacitors.
•
When a 2-terminal electret condenser microphone is used.
Speaker
Ground
MIC
Note 2 10µF
PTT switch
PTT
External
speaker,
Note 1
External
microphone,
TNC RX, etc.
TNC TX, etc.
SP
MIC
PTT
Ø2.5
plug
Ø3.5
plug
3.5 V
External
microphone
Ø3.5
plug
Ø2.5
plug
External
speaker
SW-2 10K
SW-3 27K
SW-1 3.9K
Lock SW
MIC jack
Note 1
SP jack
3.5 V
PTT switch
Note 2 10 µF