Filter
Top Products
63
11
OTHER FUNCTIONS
D Cloning error
☞ NOTE: DO NOT push any key on the sub-receiver during
cloning. This will cause a cloning error.
When the display appears as below, a cloning error has oc-
curred.
In such a case, the receiver automatically performs ALL
RESET while turning power OFF and ON.
■ Auto power-off function
The IC-R20 can be set to automatically turn OFF after a spec-
ified period in which no operation is performed.
BUSY, 120 min., 90 min., 60 min., 30 min. and OFF can be
specified. The specified period is retained even when the re-
ceiver is turned OFF by the auto power-off function. To cancel
the function, select “OFF” in step e below.
qPush [8 SET] for 1 sec. to enter set mode.
wRotate [R-DIAL] to select “AUTO POWER OFF” item, then
push [8 SET].
• Turn the expanded set mode ON for selection. (p. 49)
eRotate [R-DIAL] to select the desired time or to turn the
function OFF, then push [8 SET].
rPush [DUALWATCH] to exit set mode.
***-SET-MODE-***
-SCAN-PAUSE
>AUTO-POWER-OFF
-MONITOR
----------------
AUTO-POWER-OFF
>BUSY
-120MIN
-90MIN
-60MIN
-30MIN
-OFF
----------------
[R-DIAL]
DUALWATCH
SET
8
USING
EXPANDED SET MODE
√
MODE
ANL
AFCTSQL
FM
146 010
PSKIP
-DUP
ALL-RESET
CLONE-ERROR
Turn power OFF, then ON