Filter
Top Products
14
3
FREQUENCY AND CHANNEL SETTING
3
■ Setting a tuning step
The tuning step can be selected for each frequency band in-
dependently , however, the tuning steps, 8.33 kHz and 9 kHz,
are appeared when setting the tuning step for the VHF air
band and AM broadcast band, respectively. The following tun-
ing steps are available for the IC-R20.
• 0.01 kHz • 0.1 kHz • 1.0 kHz • 5.0 kHz • 6.25 kHz
• 8.33 kHz • 9.0 kHz • 10.0 kHz • 12.5 kHz • 15.0 kHz
• 20.0 kHz • 25.0 kHz • 30.0 kHz • 50.0 kHz • 100.0 kHz
DD
Tuning step selection
qPush [VFO MHz] to select VFO mode, if necessary.
wPush [BAND] to select the desired frequency band.
• Or, while pushing and holding [BAND], rotate the [R-DIAL] to se-
lect the desired frequency band.
ePush [9 TS] for 1 sec. to enter tuning step selecting condition.
rRotate [R-DIAL] to select the desired tuning step.
tPush [9 TS] to return to VFO mode.
■ Setting a frequency
DD
Using the dial
qPush [VFO MHz] to select VFO mode, if necessary.
wSelect the desired frequency band with [BAND].
• Or, while pushing and holding [BAND], rotate the [R-DIAL] to se-
lect the desired frequency band.
eRotate [R-DIAL] to select the desired frequency.
• The frequency changes according to the preset tuning steps.
See the left section for setting the tuning step.
• Push [VFO MHz] for 1 sec. then rotate [R-DIAL] to change the
frequency in 1 MHz steps, or push for 1 sec. again then rotate
[R-DIAL] to change the frequency in 10 MHz steps. (Each push
for 1 sec. toggles 1 MHz or 10 MHz tuning steps.)
FM
MODE
146 010
00
FM
MODE
146 010
00
[R-DIAL] changes the frequen-
cy according to the selected
tuning step.
While pushing [
VFO MHz
], [R-
DIAL] changes the frequency in
1 MHz steps (default).
[R-DIAL]
BAND
VFO
MHz
SET TS:5.0kHz
√
MODE
ANL
AFCTSQL
FM
146 010
PSKIP
-DUP
5 kHz tuning step
[R-DIAL]
TS
9
BAND
VFO
MHz