Filter
Top Products
36
7
SCAN OPERATION
■ Scan edges programming
Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 00A/00B to 24A/24B, in memory channels.
qPush [VFO MHz] to select VFO mode.
wSet the desired frequency:
➥ Select the desired band with [BAND].
➥ Set the desired frequency with [R-DIAL].
➥ Set other data
(e.g. offset frequency, duplex direction, tone
squelch, etc.), if desired.
ePush [MR S.MW] for 1 sec. to select select memory write
condition.
• 1 short and 1 long beeps sound.
•“µ ” indicator blinks.
rRotate [R-DIAL] to select the desired programmed scan
edge channel from 00A to 24A.
tPush [MR S.MW] for 1 sec.
• 3 beeps sound
• The other scan edge channel “B,” 00B to 24B, automatically se-
lected when continuing to push [MR S.MW] after programming.
yTo program a frequency for the other pair of scan edges,
00B to 24B, repeat steps w and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
[R-DIAL]
MR
S.MW
[EXAMPLE]: Programming 145.300 MHz into scan edges 03A.
√
µ
MODE
ANL
AFCTSQLTSQL
FM
FM
145 300
PSKIP
-DUP-DUP
001
√
µ
MODE
ANL
AFCTSQLTSQL
FM
145 300
PSKIP
-DUP-DUP
03A
√
µ
MODE
ANL
AFCTSQLTSQL
FM
145 300
PSKIP
-DUP-DUP
020
>CLEARCLEAR
-SKIPSKIP-:OFF:OFF
-MNAME:MNAME:
-BNAME:-BNAME:
-BANKBANK-:----:----
001001
µ
.
146
.
010
FM
>CLEARCLEAR
-SKIPSKIP-:OFF:OFF
-MNAME:MNAME:
-BNAME:-BNAME:
-BANKBANK-:----:----
03A03A
µ
.
--------------------------------
Push for 1 sec.
Rotate
MR
S.MW
Push for 1 sec.
MR
S.MW
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16