Honeywell 9951 PDAs & Smartphones User Manual


 
8 - 5
Voice Communication
You can use the Dolphin terminal as a phone over the GSM radio.
Audio Modes
The back panel of the 9900, 9950, and 9951 contains both a speaker and a microphone that you can use
to send and receive audio signals over the GSM network; see Back Panel: 9900 on page 3-6.
There are two audio modes:
Headset Headset mode is when you plug a headset into the audio jack and speak into the microphone. You
must use a 2.5mm plug; no other audio plug will fit.
Hands-Free Hands-free mode is when you use the back panel as a speakerphone. To switch the back panel to
speakerphone, in the Dialer, tap
Settings > Speakerphone. The audio levels adjust appropriately
for speakerphone use.
Volume Control
Use the Dolphin keyboard to manually adjust the volume.
To raise the volume, press the Blue modifier key + up arrow.
To lower the volume, press the Blue modifier key + down arrow.
Accessing the Dialer Window
When the GSM radio is active, tap Start > Settings > Connections tab > Dolphin Wireless Manager,
then tap Menu > Phone Settings. The Phone dialer opens.
Dialing
Once the dialer window is open you can dial out two ways:
• Tap the buttons on the dialer window.
• Use the physical keyboard (when it’s in numeric mode).
VOL
PG
Displays the network
carrier from the SIM card.
Displays the most
recent calls.