Filter
Top Products
14 - 4
Inserting and Removing Battery Packs
To insert a battery pack, place the end of the battery without the locking tab into the bottom of the charging
pocket and snap the battery into place with a hinging motion. The Status LED for that particular slot
illuminates orange when the battery has been properly inserted.
To remove a battery pack, push the locking tab down and pull the battery out from the charging slot with
a hinging motion.
Recommendations for Storing Batteries
To maintain top performance from batteries, follow these storage guidelines:
• Avoid storing batteries outside of the specified temperature range of -4 to 104° F (-20 to 40°C) or in
extremely high humidity.
• For prolonged storage, to maximize battery life, it is recommended that the battery be at a 40% - 50%
charge level, be removed from any device, and stored in a controlled temperature environment.
Charging Batteries
For best results, battery packs should be at room temperature before recharging them; temperature has
a marked effect on charging. The recommended temperature range is 50° to 95° F (10° to 35° C).
1. Set up the charger.
2. Power the charger.
3. Insert batteries into the appropriate slots.
The Status LED for each slot turns orange to indicate that the battery has begun a charge cycle.
4. When the Status LED turns green, the battery in the slot has completed charging.