Honeywell 9951 PDAs & Smartphones User Manual


 
3 - 9
Back Panel Features for the 9900, 9950, and 9951
Battery Well
The Battery Well is a recessed area on the back panel that holds the Li-ion battery pack.
For more information, see Batteries on page 3-14.
Fastener for the Stylus Tether
Stylus tethers can be purchased separately to help you keep the stylus attached to the 9900
when not in the slot to prevent loss. A stylus tether is a coiled, elastic cord with one end that
can be attached to the stylus and another attached to the back panel.
Image/Scan Engine Window
The available image engines read and decode linear, stacked linear (e.g., PDF417), and 2D
matrix bar code symbologies. The available laser engines contain a laser aimer for greater
accuracy.
The laser apertures for the laser aimers for both the image engines and the scan engines are
contained behind this window.
For more details, see Using the Scan Image Engine on page 4-1.
Microphone
The integrated microphone that provides audio input to the terminal when a headset is not
plugged into the Audio Jack, page 3-10. When a headset is plugged in, the terminal defaults
to the microphone on the headset.
Rear Speaker
The integrated speaker that sounds audio signals as you scan bar code labels and enter data.
The operating frequency range is 500Hz at 71 dB up to 80 dB.
Stylus Slot
The stylus is used to operate the touch panel. The back panel features this storage slot to hold
the stylus when not in use.
The stylus features a special tip for added accuracy and ease of use.