Filter
Top Products
11 - 6
Charging the Main Battery
The base powers the terminal and fully charges its main battery pack in 4.5
hours.
The base contains an intelligent battery charging system that protects the
battery from being damaged by overcharging. The unit senses when a
battery pack is fully charged and automatically turns off the charger. If the
battery voltage drops below the charge threshold, the charger will again
turn on to maintain the battery at full capacity. As a result, Dolphin
terminals may be stored in the base indefinitely without damage to the
terminals, battery packs, or peripherals.
To check battery power, use the Power system setting; see Power on page
6-12.
For more information about Honeywell Li-ion batteries, see Batteries on
page 3-14.
To Power a Terminal and Charge its Main Battery
1. Install the battery pack in the terminal; see Install the Main Battery
Pack on page 2-1.
2. Connect the base to the power supply provided by Honeywell.
3. Slide the terminal into the terminal well until the Dock LED lights green
to indicate that the terminal is properly seated.
4. The battery pack begins charging.
Make sure the terminal is dry before placing it in the base. Do NOT place a
wet terminal in the base! Doing so may cause damage not covered by the warranty.
Charging a Spare Battery in the Auxiliary Battery Well
The auxiliary battery well located on the back of the base charges a spare battery independently of the
terminal well. The Aux Battery LED on the front panel indicates the status of the battery in this well.
Charge time is 4 hours; see Auxiliary Battery Well on page 11-3.
1. Insert the end of the battery without the locking tab into the bottom of the auxiliary well opening.
Note: The following warnings apply to 99XXXXX-XXXXXXI units (Hazardous Location rated. See Approvals by
Country on page 1-3.).
Replace only with battery pack type 200002586 manufactured by Honeywell International Incorporated.
Warning: Explosion Hazard. Charge or replace the battery only in an area known to be non-hazardous.
Warning: Explosion Hazard. Do not replace components unless power has been switched off or the area
is known to be non-hazardous.
Warning: Substitution of any components may impair suitability.
Warning: Explosion Hazard. Do not use external connectors in areas known to be hazardous.
D
OC
K
A
UX
B
A
T
T
E
RY
COM
M
!
!
!
!
!
!