Filter
Top Products
Glossary of Terms
ADSL Asymmetric Digital Subscriber Line: Modems attached to twisted pair copper wiring that transmit
from 1.5 Mbps to 9 Mbps downstream (to the subscriber) and from 16 kbps to 800 kbps upstream,
depending on line distance.
AGC Automatic Gain Control is an electronic system found in many types of devices. Its purpose is to
ing range of
RP Address Re
Pv
ope
is used when Ethernet
ATA Analo se a VoIP data
network.
CODEC Ab gital-to-analog (D/A)
converter fo signals from the outside world to digital, and back again.
comm
DAT
s s
DECIM or
compre
Digital Enhanced Cordless Telecommunications: A standard developed by the European
Telecommunication Standard Institute from 1988, governing pan-European digital mobile telephony.
DECT covers wireless PBXs, telepoint, residential cordless telephones, wireless access to the public
switched telephone network, Closed User Groups (CUGs), Local Area Networks, and wireless local loop.
The DECT Common Interface radio standard is a multi-carrier time division multiple access, time division
duplex (MC-TDMA-TDD) radio transmission technique using ten radio frequency channels from 1880 to
1930 MHz, each divided into 24 time slots of 10ms, and twelve full-duplex accesses per carrier, for a total
of 120 possible combinations. A DECT base station (an RFP, Radio Fixed Part) can transmit all 12
possible accesses (time slots) simultaneously by using different frequencies or using only one frequency.
All signaling information is transmitted from the RFP within a multi-frame (16 frames). Voice signals are
digitally encoded into a 32 Kbit/s signal using Adaptive Differential Pulse Code Modulation.
DNS Short for Domain Name System (or Service or Server), an Internet service that translates domain
names into IP addresses
DID Direct Inward Dialing. The ability for an outside caller to dial to a PBX extension without going
through an attendant or auto-attendant.
DSP Digital Signal Processor. A specialized CPU used for digital signal processing. Grandstream
products all have DSP chips built inside.
DTMF Dual Tone Multi Frequency. The standard tone-pairs used on telephone terminals for dialing
using in-band signaling. The standards define 16 tone-pairs (0-9, #, * and A-F) although most terminals
support only 12 of them (0-9, * and #).
control the gain of a system in order to maintain some measure of performance over a chang
rea
l world conditions.
solution Protocol is a protocol used by the Internet Protocol (IP) [RFC826], specifically
A
I
4, to map IP network addresses to the hardware addresses used by a data link protocol. The protocol
rates below the network layer as a part of the interface between the OSI network and OSI link layer. It
IP
v4 is used over
g Telephone Adapter. Used to convert analog telephone signal in order to u
breviation for Coder-Decoder. It's an analog-to-digital (A/D) and di
r translating the
CN
G Comfort Noise Generator, generate artificial background noise used in radio and wireless
u cations to fill the silent time in a transmission resulting from voice activity detection.
ni
AGRAM A data packet carrying its own address information so it can be independently routed from
ource to the destination computer
it
ATE To discard portions of a signal in order to reduce the amount of information to be encoded
ssed. Lossy compression algorithms ordinarily decimate while sub-sampling.
DECT
Grandstream Networks, Inc. GXP-2000 Users Manual Page 30 of 33
Firmware 1.1.1.14 Last Updated: 12/2006