Filter
Top Products
48
Handset Sound Signals
Signal Meaning
A long warbling tone (with ringer on) Signals an incoming call
Three short beeps Page signal
One long beep Conrmation tone for the
completion of a function
One short beep (during room monitoring mode) Ring alert tone
One short beep (every 7 seconds) Low battery warning
Troubleshooting Guide
Telephone Solutions
No dial tone
• Check and
repeat installation steps:
Ensure the base power cord is connected to a working electrical outlet .
Ensure the telephone line cord is connected to the base and the wall jack.
• Connect another phone to the same jack; if there is still no dial tone, the problem
might be your wiring or local service.
• The handset may be out of range of the base. Move closer to the base.
• Ensure the battery is properly charged (16 hours).
• Ensure the battery pack is installed correctly.
• The handset should beep when you press the
TALK button and the charge
indicator should be lit when the handset rests in the cradle. If not, the battery
may need to be charged.
• Place handset in charge cradle for at least 0 seconds to reset the unit.
Handset does not ring
• Make sure the handset ringer switch is set to ON, this can be done through the
handset setup menu - Ringer Volume.
• The handset may be out of range. Move closer to the base.
• You may have too many extension phones on your line. Try unplugging some
phones.
• Check for dial tone.