Filter
Top Products
1
7. Use the number keys to enter the time and use the or button to select
AM or PM.
8. Press the
Store (SKL) button to save the settings. You will hear a conrmation tone.
9.
Allow the phone to charge for 16 hours prior to rst use. If you don’t properly
charge the phone, battery performance is compromised.
CAUTION: To
reduce risk of personal injury, re or damage
use only the 5-2812 power adaptor listed in the user’s guide.
This power adaptor is intended to be correctly orientated in a
vertical or oor mount position.
BlueTooth
®
Setup
This unit supports a maximum of two Bluetooth cell phone devices. To use you
Bluetooth cell phone device with the 817 System, you must activate Bluetooth on
your device and then pair the device to the base.
NOTE: Your Bluetooth cell phone device should be within 2 feet
to 10 feet from the base. If the device is too close it may create
undesired noise. If device is too far it will not pair.
Connect (and pair)
1. Make sure your phone is OFF (not in talk mode).
. Press and hold the
CELL 1 or CELL 2 button on base until the corresponding LED
ashes. (refer to the instruction manual for your cell phone device on the
proper procedure to add and pair a new device)
When “CELL FUSION” is shown on the device.
. Use the number keys to enter the default PIN
0000 on your Bluetooth cell phone
device. When the device is paired successful, the corresponding LED illuminates.
Disconnect
Press and hold the CELL 1 or CELL 2 button to disconnect the Bluetooth cell phone.
The CELL 1 or CELL 2 indicator will no longer be illuminated.
Reconnect
Press and release the CELL 1 or CELL 2 button again and the connection will resume.
NOTE: Certain cell phones may require an acceptance to allow
reconnection.